VimNet Explorer Utility v9.1.5.12 Release Notes

These release notes are for the VimNet Explorer Utility version 9.1.5.12. The previous version is 9.1.5.11.

Product Description:

These release notes are for the VimNet Explorer Utility version 9.1.5.12. The previous version is 9.1.5.11.

Who should upgrade?

Recommended for all users of VimNet Explorer

What Is New In This Release?

1. Gateway IP address edit field may be enable in "Physical Network Properties" dialog, rather than editing in registry
2. VIM diagnostics, Enable remote logging from VIM in settings (File/Settings), rather than editing in registry
3. Ethernet/IP version 4x detail display, display extended address and remote destination routing if configured
4. VIM diagnostics, hold column size between tree element types

The following defects were corrected:

1. Removed unused tool bar elements
2. Modified diagnostic logging display dialog to resize correctly
3. In Add VIM, check IP address and subnet for valid IP specification formats to prevent invalid IP addresses from being entered into VIM
4. During VIM download of EPROM configurations, check for failure of message read-back matching, fail download and display error message,
5. For Ethernet/IP datasets detail display, display correct controller name rather than generic "NODE1"
6. Prevent UCMM message detail (file number) from being reset on opening of definition edit dialog.
7. VIM diagnostics, on failure reading configuration from primary, try secondary
8. Ethernet/IP version 4x DF1 messages allow selection of block output or single value writes.

Please contact us for any questions about these release notes at:

MYNAH Technologies
504 Trade Center Boulevard
Chesterfield, MO 63005 USA
+1-636-728-2000 (voice)
+1-636-728-2001 (fax)
email: support@mynah.com