Virtual IO Module (VIM) Network Gateway provides a native DeltaV IO Interface to open plant Ethernet networks and devices that use the Modbus TCP/IP or Ethernet/IP protocol.

DeltaV Controllers can read and write signals from plant floor devices that use these Ethernet networks such as PLCs, Motor Control Centers, and Weigh Scales.

Key features of the DeltaV Virtual IO Module:

• Seamless Integration with DeltaV. Each Virtual IO Module is seen by the controller as up to 4 Virtual DeltaV Serial Cards. Commissioned Virtual IO Modules are auto-sensed by DeltaV auto-sense IO function as DeltaV Serial Card(s). Data set configuration is done in the DeltaV Explorer in the same manner as a DeltaV Serial Card. IO signals can be used in DeltaV Control Modules and displayed on DeltaV Operator graphics.
  

• Intuitive Network Setup. The VIMNet Explorer utility makes setup of the Virtual IO Module easy and intuitive. Graphical, drag and drop functionality makes setting up the plant Ethernet network quick and easy.

• Powerful Integration Solution. Each Virtual IO Module can emulate up to 4 DeltaV serial cards and support up to 128 Serial Card Datasets of information from 32 network addresses. Communication over the plant Ethernet network is fast and efficient. User configurable IP addressing allows the Virtual IO Module to be used in almost any plant environment regardless of network scheme.

• Modular, Flexible Package. The DeltaV Virtual IO Module mounts in the same manner as the DeltaV controller. It uses a DeltaV 2-wide or 4wide carrier and Power Supply connect to the DeltaV IO Bus by the carrier side connector.